Halloween Place Card Holders to Make (1940's)

[phpbay]halloween place card, 12, “”, “”[/phpbay]

To make a spiral as a support for cut-out witches, cats, bats, pumpkins, ghosts, tombstones, etc…

  1. Use about 20 inches of wire for a 4-inch place card.
  2. Four inches from the end, bend the wire at right angles.
  3. One inch from this point bend sideways and start the spiral, holding the wire flat on the table with the 4-inch length extending straight up to insure a flat spiral.
  4. About three full circles will make a strong base.
  5. Wires may be wrapped with crepe paper if desired.
Related Posts Plugin for WordPress, Blogger...

Leave a Reply

Your email address will not be published. Required fields are marked *

The maximum upload file size: 64 MB. You can upload: image, audio, video, document, spreadsheet, interactive, other. Links to YouTube, Facebook, Twitter and other services inserted in the comment text will be automatically embedded. Drop file here